Logo

P03C7 Engine Trouble Code

Meaning of P03C7 engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P03C7 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P03C7 code is occuring now you should check P03C7 repair processes.
Now don't ask yourself; What should you do with P03C7 code ?
The solution is here :

P03C7 Possible Solution:

P03C7 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

P03C7 Code Meaning :

P 0 3 c 7
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Intake Valve Control Solenoid Circuit Low Throttle/Pedal Position Sensor/Switch A Circuit Intermittent Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P03C7 OBD-II Diagnostic Powertrain (P) Trouble Code Description

P03C7 engine trouble code is about Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical.

Main reason For P03C7 Code

The reason of P03C7 OBD-II Engine Trouble Code is Throttle/Pedal Position Sensor/Switch A Circuit Intermittent.

P03C7 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.